Before You Start

The kiosk has 2 card dispensers (also called hoppers). This guide shows how to remove one and replace it with a new one.

Tools you will need

• A screwdriver that fits the size 10 nuts.

The kiosk must be powered off before you begin. Do not do this work with the kiosk turned on.

Instructions

1. Switch the power strip off on the back wall of the opened kiosk.
   
2. Pull the tray containing the dispensers forward.
3. Locate the dispenser you want to replace.
   
4. From the back of the dispenser, remove the 12 pin connector.
5. Remove the 3 pin connector to the left of the 12 pin.
   
6. From the front of the dispenser, remove the two remaining connectors.
   
7. Using a size 10 screwdriver, remove the two nuts holding the dispenser in place.
   
8. Slide the dispenser forward, up, and out of its position.
   
9. Place the new dispenser over the fastening screws and slide it back into place.
10. Screw the nuts back on.
11. Reconnect the two front cables.
    
12. Reconnect the two back cables.
13. Slide the dispenser tray back into the kiosk.
14. Turn on the power strip at the back wall of the kiosk.
15. Close the kiosk back up.